<$BlogRSDUrl$>

Friday, November 29, 2013

Brought gateway back in and reset  

Seems to be communicating


Monday, November 25, 2013

White hive monitor batteries changed  

New Duracells


White hive monitor batteries changed 


Saturday, November 23, 2013

Pink hive monitor batteries replaced 

Fresh duracells

Thursday, November 21, 2013

I've been worrying about the low readings from my new arnia.co.uk sensors  

This is in my white WBC hive,  brood box. Readings are typically only a few degrees above the sensor which is on the outside of the brood box between the two skins above the entrance.

The current configuration is brood box with two honey filled supers. When I installed the internal sensor the weather was too cold to open the hive. I cracked open the joint above the brood and just pushed in the sensor far enough to reach the centre of the box, but I don't know what direction it went in.

I have now come to the conclusion that the sensor is nowhere near the cluster, in particular it must have ended up below it. A temperature reading on the crown board is warmer, so there are bees there.

I will try and contain myself until warmer weather to reposition the sensor.


Wednesday, November 20, 2013

Pink hive monitor failed after 17:00 upload 

Must be low battery, last reading was 5.2V, although the white hive is still operating at a lower voltage.

Saturday, November 16, 2013

Sunny but cold 

Bees flying, busy from the pink hive, a cloud in front and many on the landing board. Fewer from the white, but some activity


Monday, November 11, 2013

Miserable and wet all day, no flying 


Sunday, November 10, 2013

Bees flying in pale winter sunshine  


This page is powered by Blogger. Isn't yours?